![]() ![]() Design a new cam profile to meet the desired requirements without largely. The problem is using this much operation in the sketch the system is not able to take up the load and slows down and my time to model it gets increased so practically its not possible. Figure 3.11 Scatter point chart made with the Microsoft Excel software. my deadline is approaching so please help me to get this done. I found it only on a video on youtube after hours of searching but without any code or even a description if it can be done on matlab or not. ![]() Similarly for one roller to other and from that one to the next one the process is continuedĪs of dwell portions is concerned there wont be any problem since we could use an arc I have a home-project to develop linear cam profile with roller follower In the way that appear in the picture. Now tangential line is drawn from one roller to other separately ![]() Now roller circles are been drawn on one point and then it can be patterned to all other points(Say for example if we have coordinates for each angle we get 360 circles this too increases if the angles are incremented by 0.5 degree) Points of roller center's are been imported from an excel file as the above mentioned method Thing to be noted Roller's center polar coordinates are only known not the point where the cam gets in contact with the roller if so i could use this method and this might work.Īctually i used this by converting my coordinates by subtracting the roller radius to get the contact point but only for dwell regions it works and for a rise and falls to get the tangential contact, my method of subtracting the roller radius fails. Exactly tried this method once and unfortunately got the cam profile to be wrong. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |