![]() ![]() Currently it is not possible the set the frequency of the radio directly as this is not supported by the OWI interface.Important: The UHF Radio configuration set in the receiver should be names "UHF RADIO". The radio channel represents an offset from a center frequency as used by the integrated radio receiver. When the UHF Radio source is selected the user may setup the radio channel. The switching of configuration is implemented by switching the active configuration set of the receiver and optionally setting some parameters. ![]() ![]() The supported types are UHF Radio, GSM Data and NETPOS based corrections. The driver allows the user to select one of three correction source types. In order to decode the COG and/or SOG the user should enable the $-VTG message with the required update rate. In order to decode the position the user should enable the $-GGA output with the required update rate. The output from the terminal port is used decode the position, COG & SOG. When this driver is started the UI allows the user to setup the NMEA messages which should outputted by the receiver on the terminal port and on port 2. Each change in the driver settings should be followed by a click on the 'Send' button in order to transmit the updated settings to the receiver. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |